AR-314 LOW PASS FILTER MODULE
The
AR-314 is a basic 12db-peroctave low pass filter with voltage controllable
cut-of frequency and variable resonance (Q). This filter modifies the
harmonic content, or spectrum, of an incoming signal by damping all frequency
components of the waveform above a certain cut-off point. The resonance
control boosts the amplitude of the frequency, or harmonic of the incoming
wave, closest to the cut-off frequency, by a variable amount according
to the manual setting. The control input varies the cut-off frequency
at 1 octave per volt of input signal: positive voltage will raise the
cut-off and negative voltage
will lower it.
SPECIFICATIONS:
•
Frequency Response: 16Hz to 16KHz
• Q (Gain at Cut-off Freq.): 0.5 to 50
• Maximum Signal Level: +/-10v. peak
• Signal-to-Noice Ratio: 70db min.
• Control Input: +/-10v; 0v-1v./octave
• Signal Input Impedance: 50 ohms min.
• Control Input Impedance: 50 ohms min.
• Output Impedance: 1K ohms
• Control:
• Q (Gain at Cut-off Freq.): 0.5 to 50
• Maximum Signal Level: +/-10v. peak
• Signal-to-Noice Ratio: 70db min.
• Control Input: +/-10v; 0v-1v./octave
• Signal Input Impedance: 50 ohms min.
• Control Input Impedance: 50 ohms min.
• Output Impedance: 1K ohms
• Control:
•
Initial Freq., Resonance (Q), Signal 1 Input Attenuator
Control 1 Input Attenuator
• Connectors: • 4 Signal Inputs
• 4 Control Inputs
• 2 Outputs
• Power Consumption:
• Connectors: • 4 Signal Inputs
• 4 Control Inputs
• 2 Outputs
• Power Consumption:
• 28mA at +15. D.C
• 28mA at -15. D.C
• 28mA at -15. D.C
